Our team of specialists repairs angle grinders , electric saws, surface and submersible pumps, washing machines, repairs hammer drills , electric drills, screwdrivers, vacuum cleaners, refrigerators, electric scythes, meat grinders, food processors, lawn mowers and electric motors. We change the stator winding and anchor of a synchronous or asynchronous electric motor, we restore the rotor brushless motor
Diagnostics are performed, if necessary, replacement of the winding and collector of the electrical part and consumables (wires, buttons, brushes, bearings)
Repair of electric motors in any region of Ukraine
For repairs, you need to send the engine to us, having previously contacted us using the contacts
Here are approximate prices for repairing a lawn mower electric motor or prices for repairing a trimmer electric motor

We repair any collector motors (including asynchronous ones) with a collector diameter of at least 21 mm and brushless electric motors

For repair, the product must be sent to us at the address below. Please include in the parcel brief description of the breakdown, preliminary diagnosis and complaints about the operation of the equipment, indicate the full model of the equipment. Before sending contact us using the contacts above and agree on what exactly you intend to send. Depending on the volume and weight of the parcel, we will give you one of the addresses for acceptance for repair. The work period depends on the seasonal workload of the craftsmen and can take from 3 to 15 working days, longer when eliminating complex defects. After the work is successfully completed, our operator will contact you to send the parts. If your anchor or electric motor has mechanical damage , such as a bent shaft or damage to the bearing seats , We may return the part without repair , since restoring the original geometry of the parts is technically too expensive and does not make sense, given the cost of new equipment.

Attention! Important agreement!

If you send parts with bearings on and they are already worn out, we will replace them. without agreement and include it in the price! If we receive a separate anchor and the cooling impeller is put on, we remove it and put it on conditionally (or do not put it on) without coordination , since the position of the impeller must be adjusted during assembly for proper engine operation.

If a pulley for a belt drive is pressed onto the shaft, it is impossible to remove it, we cut it off and make a new one, here is the price for a lawn mower pulley